TreePerch Tree-Strap Gear Hanger – 3D Printed Outdoor Hook

$35.00

Hang light gear on a tree without screws. TreePerch is a one-piece 3D-printed hanger that straps to the trunk and has two built-in hooks.

WHAT YOU GET

- 1 printed TreePerch body in PETG, Black or Army Green (choose at checkout)

- 1-inch-wide polyester strap with a dual-adjust side-release buckle (choose 5 ft or 8 ft at checkout)

STRAP LENGTH

- 5 ft: fits trees about 6–15 in across

- 8 ft: fits trees up to about 27 in across

Tree-diameter ranges are approximate.

SIZE

- Body: 100 × 86 × 63 mm (about 3.9 × 3.4 × 2.5 in)

- Curved back, made to sit against the trunk

- Two built-in hooks, each 18 mm wide with 44 mm reach

HOW TO USE

- Thread the bare strap end through the slots first; the buckle will not pass through the slots

- Wrap the strap around the tree and fasten the buckle at the side

- Hang only light items: gloves, hats, calls, binoculars and small bags

- Remove the hanger after use

PLEASE NOTE

- This hanger has no load or weight rating

- Not for bows, rifles, full packs, climbing, or holding a person

- Confirm the strap length on your tree before relying on the fit

MATERIAL

- Body printed in PETG (Black or Army Green)

- 1-inch-wide non-stretch polyester webbing and a dual-adjust side-release buckle

SHIPPING

- US shipping is $9.99 per order under $99, and free on orders of $99 or more

- Canada $24.99; other international $49.99

- Processing takes 1–3 business days

MADE TO ORDER

Each hanger is printed to order in our small home studio. Small layer lines and slight color variations are normal for 3D printing.

Questions or a custom request? Contact us!

Hook Pack (optional add-on): 2 small J-hooks and 1 wide hook. Both styles thread onto the same strap through TreePerch's slots. For light gear like gloves, hats, lanyards, and small bags.